|
|
|
|
|
|
Southwire SP-3-UPC Hammer Protection Plate, 3 in L, 1-1/2 in W, 1/16 in Thick, Steel, Galvanized
|
|
|
Southwire Hammer Protection Plate, Steel, Galvanized, Silver, 3 in L, 1-1/2 in W, 1/16 in Thick
|
|
|
|
|
|
|
|
|
|
Raco 2709 Cable Protector Plate, 2.563 in L, 1-1/2 in W, 1/16 in Thick, Aluminum, Pre-Galvanized
|
|
|
Cable protector plates for wood studs. Standard type/non-gangable. Protects non-metallic sheathed cable or raceway type wires running through wood studs from accidental nail, screw or drill penetration. Also applies to plumbing to protect nonmetallic piping. No nails required. Pre-galvanized steel construction for added corrosion protection. No additional hardware required, just position and hammer down spurs. UL, cULus Listed.
|
|
|
|
|
|
|
|
|
|
Gardner Bender GSP-04 Twist-Apart Spacer, Plastic, Green
|
|
|
Adjusts depth of receptacles and switches to allow proper fit of trim plate.
|
|
|
|
|
|
|
|
|
|
Gardner Bender GSP-24 Twist-Apart Spacer, Plastic, Red
|
|
|
Adjusts depth of receptacles and switches to allow proper fit of trim plate.
|
|
|
|
|
|
|
|
|
|
Gardner Bender HST-WP Butt Splice Kit, 600 V, 14 to 8 AWG Wire, Black
|
|
|
For waterproof repair of well pipe cables and splices of stranded cable #8-#14 AWG. Connector set screws engage each wire securely for a solid splice. Rated 600 V maximum. Contains one screw splice connector, one 4 in heavy polyolefin shrink tube with watertight adhesive liner.
|
|
|
|
|
|
|
|
|
|
Gardner Bender HSB-28 Butt Splice Kit, 600 V, 8 to 2 AWG Wire, Black
|
|
|
For waterproof installation or repair of #2 to 8 AWG copper cable. Seal with heat gun or torch. Rated 600 V maximum. Contains one screw splice connector, one 4 in heavy polyolefin shrink tube with watertight adhesive liner.
|
|
|
|
|
|
|
|
|
|
Madison Electric MEIBB Bonding Bridge Connector, 1/2 in, #10 Wire, Zinc
|
|
|
Madison's done it again. Our new inline intersystem bonding bridge will change the way you ground all of your conductors from your utilities. It provides a dependable method for grounding and bonding for electrical systems. Typical applications include communications, solar, cable and transmission lines. The MEIBB's innovative design keeps the main ground conductor isolated from communications lines. It also eliminates creating holes in the building that could allow ingress of water. When used with conduit, it provides protection against damage and theft of the main ground.
|
|
|
|
|
|
|
|
|
|
Gardner Bender 42-035 Pocket-Sized Wire Markers Booklet
|
|
|
GB Pocket-Sized Wire Markers Booklet, Includes: (6) 1 - 15, (4) 16 - 90, (2) A - Z, (2) +, (2) -, (2) /, (2) 0
|
|
|
|
|
|
|
|
|
|
Halex 51063 Wedge Clamp Connector, Aluminum Housing Material
|
|
|
For NM cable and SE cable. Aluminum wedge and shell, with stainless steel bail. Indoor or outdoor applications. Use to connect a triplex overhead service entrance cable to a mounting device on a building. Bulk packed.
|
|
|
|
|
|
|
|
|
|
Halex 62899 Nail Plate, 1-1/2 in L, 2-1/2 in W, Aluminum
|
|
|
Use to protect internal wire runs from nail punctures, as defined in the NEC Article 300-4.
|
|
|
|
